anyone have a proper tested solution for pcr2.1 do not want launch control just a hardcut limiter set at 4500rpm stationary and whilst driving. willing to pay after test, may thanks
I'm searching an ori file for an audi A3 3.2 v6, already tuned, but lot of trouble, as usual ^^
I find an ori, but not 100% compatible.
Will do the job for a back to stock revert on the readed file, but i always prefer to start again with an 100% original file. (so i'm sure i didn't miss something)
Find attached : tuned file, a closed ori file but not 100% compatible
Hello Everyone. I have a Volvo XC60 from 2015. Sensor: P31406637, Bosch: 0285012268. The original sensor has a complete lack of communication. It was purchased used with identical numbers but has an accident recorded. Please remove the accident. Thank you, best regards.
Hi everyone on the forum, I'm trying to do hardcut on this med17.5 ecu, my question is if KFSZFRL (60AF6 on this file) is enough or there is another strategy to activate it on these ecus, any hints are appreciated, thanks u so much!
Hello, can anybody help me connect my ICOM next (OEM interface) through wifi? I setup the connection and password but for some unknown reason the ICOM is not connecting to my wifi netwok
After the egr was remove car started to idle rough. I think that it is because when it is idling egr is 10% open and a good portion of exhaust is recirculated and now it is closed so there is more air going into turbo which is closed a good a good amount because it is a vgt turbo. I think that it idles because exhaust cant go anywhere because of the way turbo close up at low rpms and egr blanked. I think that opening it more at idle should fix the problem, could someone do that? I sent the original file and the one I am currently running with egr off.
Hi, i'm from Spain, I like to retrofit my father w168 170cdi with tempomat. The problem is the coding with HHT only can accept whit auto gear box and the car is manual. If i code like an auto the tempomat works fine but engine is limp mode cause dont see the auto gearbox ecu. I like to learn how the EPC variant code table works because the ecu Accept more Codes than the table. Will pay for information. Thanks
Hello members.Need help in deactivating MAF and limitation for this in that focus 16tdci
I tried but not work well....have anybody worked solution?
thanks