|
|
Jeep Wrangler BACK-UP |
Posted by: 29f400 - 11-08-2012, 03:06 AM - Forum: Automotive Tuning.
- No Replies
|
 |
hello looking for a back-up ecu 0281013661 a 2007 Jeep.
came blocked by an ECU by OBD for trying to read a bad grassy
a greeting
|
|
|
P.Boxer 2.2 VISTEON |
Posted by: 29f400 - 11-08-2012, 03:03 AM - Forum: Automotive Tuning.
- No Replies
|
 |
HELLO I HAVE A BURN UNIT OF THE ECU IS A BOXER VISTEON ...
SW 96626662 80
96612569 HW 80
THE QUESTION IS WHERE YOU WILL CLONE ESSA IMMO ECU no problem
|
|
|
Good diagnostic tool for european cars |
Posted by: mathias - 11-07-2012, 04:21 AM - Forum: Automotive Hardware.
- Replies (4)
|
 |
Hello
can some one give me advice on a good diagnostic tool for European cars like Volvo ,Saab,BMW,Opel,Nissan,merc,Honda,Toyota,Ford ?
for the vw Audi seat skoda i have the original vagcom.it is okej..
and i have a autocom cdp+ 2011.3 clone i don´t like to mutch..
to many cars i can´t communicate width
witch one is the best all scanner/diagnostic tools on the market ?
autel maxidas 708,,launch 431,,Bosch kts..??
Best regards mathias
|
|
|
Problem firmware autocom |
Posted by: smilecars - 11-07-2012, 04:16 AM - Forum: Bosch, Actia, Autocom Discussions.
- Replies (89)
|
 |
Hello to all friends.
I have a problem with two "AUTOCOM".
First problem: On a "AUTOCOM", I can not update the firmware. Everything works fine, and it connects to the machine, but when I try to update the firmware, I connect my tester with usb and power, two red LEDs light up, click on the button: firmware updates, you hear a quick click of a relay , and after a few seconds, update error, check cable, power supply, etc. ... The LED is not flashing green, the two red LEDs remain fixed.
Second problem: another "AUTOCOM" after connected, usb and power, when I click the Test button, test not ok:
Write:
Serial: 30250
Firmware: not loaded
Not with other information, and you can not do the firmware update
You have a solution for these my problems?
Thanks in advance
|
|
|
RENAULT TRUCKS ( IMMO , TACHOGRAPH , DASHBOARD , VDO "VECU" , TRANS CONTROL ) |
Posted by: eng_hti - 11-06-2012, 06:34 PM - Forum: Automotive Airbag, Dash, ECU, IMMO.
- No Replies
|
 |
PLEASE GIVE ADICE TO COVER ALL RENAULT TRUCKS ELECTRONIC SYSTEM :
1- HOW TO CHANGE SPEED LIMIT ( PREMIUM FROM 2001 TILL NOW ) ?
2- HOW TO PROGRAMME DASHBOARD AND CHANGE INSTALLED LANGUAGES ?
3-HOW TO PROGRAMME IMMO SYSTEM & HOW TO MAKE IMMO OFF ?
HOW TO MAKE VDO COMPATIBLE WITH ALL IMMO SYSTEM COMPONENTS IF CHANGED ?
4-HOW TO PROGRAMME RENAULT TRUCKS TACHOGRAPH ?
AVALIABLE TOOLS :
TANGO KEY PROGRAMMER , ORANGE 5 PROGRAMMER , SIVAVA PROGRAMMER
TARGET MODELS :
PREMIUM , KERAX , MIDLUM , MAGNUM
PLEASE GIVE SUPPORT WITH PICTURES & VIDEOS &SOFTWARE
62 view without 1 reply ......please share your info & ideas
Thanks ,
(11-06-2012, 06:34 PM)eng_hti Wrote: PLEASE GIVE ADICE TO COVER ALL RENAULT TRUCKS ELECTRONIC SYSTEM :
1- HOW TO CHANGE SPEED LIMIT ( PREMIUM FROM 2001 TILL NOW ) ?
2- HOW TO PROGRAMME DASHBOARD AND CHANGE INSTALLED LANGUAGES ?
3-HOW TO PROGRAMME IMMO SYSTEM & HOW TO MAKE IMMO OFF ?
HOW TO MAKE VDO COMPATIBLE WITH ALL IMMO SYSTEM COMPONENTS IF CHANGED ?
4-HOW TO PROGRAMME RENAULT TRUCKS TACHOGRAPH ?
AVALIABLE TOOLS :
TANGO KEY PROGRAMMER , ORANGE 5 PROGRAMMER , SIVAVA PROGRAMMER
TARGET MODELS :
PREMIUM , KERAX , MIDLUM , MAGNUM
PLEASE GIVE SUPPORT WITH PICTURES & VIDEOS &SOFTWARE
|
|
|
|