Someone can help with manual Solution for this Ducato File?
Ecu is Manetti Marelli 9df HW002 Ecu, from 2020 Ducato 131HP.
Need EGR , DPF and DTC P242E-15 off. Automatic Version dont work, car smokes .
Dont want for free...
Hello sir
i need help to replace the this ecu . i have gone to the car
more than 4 times and all virgin files i got failed me
kindly help me with a tested virgin file for me to match with Star
eeptom is x24c02.
i have attached image of ecu .
thanks to all
Hi, i'm looking for cheap edc16 read/write tool through obd with checksum. I have ori pcmflash + scanmatik 2 pro for other ecus but i can't find module for edc 16 :/ Mpps will be good? Or should i look for something else? Thanks for help!
Ps. I'm just learning for now and i will use it mostly for vag ecus
I have a Citroen DS3 THP acknowledging the fault P0340, but already checked with the oscilloscope that the sensor is OK. The wiring is also OK.
Using the xtool scanner, I noticed that there were some errors of type: Crankshaft Target Adaptation under Deceleration - "Not Done"
Input Camshaft dephaser programming status - "Not Programmed".
Is there any procedure to be done for this learning to be done?
Hello all, we have 2 ecu from E39 serie 5 3.0L
On first ecu all are off with EWS off from flash file attached. And we have second BMW SERIE 5 E39 ecu. Also I read flash. Anyone can copy the good map from first ecu to the second (checksum,...?) ITs for swapping project. I tested first ecu and all works.
**Latest version ** VOLVO TECH TOOL (PTT) 2.8.310 real instalation with Codemeter Activation Development mode. Instalation via teamweaver send ID teamweaver for instalation.
Volvo Premium Tech Tool software is designed to diagnose and program Volvo Trucks and Buses,
Volvo Construction Equipment, Volvo Penta, Mack trunks, Renault trucks, UD trucks.
Hello , i need immo off on this Fiat dublo 2007 1.6 ecu marelli 4AF.G3 HW407 with body version , i read flash with kess v2 and eeprom with FVDI , can someone help me ? please
I have been asked to programme a new electronic steering lock on a Citroen C4 Cactus 1.2 petrol 2020. It has no ignition after new lock was fitted and when I first plug in I only get communication with BSi, I went in to pack repair found replacement parts but can't see anything in BSi for me to programme new lock.
Anyone give me advise on how to execute this task? I don't do a lot of PSA so a little un familiar
Dear all, I have tried two DPF off files from file services which also turn off the EGR (while I only asked for DPF off). One fileservice also disabled the EGT sensors. I would like to keep the EGT sensors working, the EGR on and the DPF off. The car still has its original downpipe (without DPF). Does anyone have a working solution? I have attached the original file.
Hi. I looking for good good tested solution to make CAT OFF P0420 in Marelli 9gf. I try couple solution but after day or few kilometers check angine light back on with DTC P0000
Hi, i wrote EGR off file into ECU, but car doors dont lock up anymore. You press the key button and they dont work.
Is anyone able to check if it's all ok?
tysm
Citroen C5 2.0 RHH engine
163 HP 120kw,
manual gearbox
350.000km on dashboard
from 2010
HW 9666098180 SW 9666098180 UPG. SW 9667088680
FAP active, and on car.
I have buy this car 3 monts ago.
bad fuel injector, 2 with return valve, and 2 with post injection. All fuel injector replaced, the car ecu did not make autocorect strategy on idle (the car show 1ms corection for all injector)
i have made a backup of ecu.
i dont know if its original or no.
i am curious if this car can achieve better fuel consumption.
