[font="MHH Font", Calibri, sans-serif]Hello everyone, I am adjusting the mileage of a Renault Laguna 3 that has passed 999,999km, I have adjusted the mileage of the instrument panel to 1000km as if a new panel had been installed, but in this car it is also necessary to modify the mileage in the ABS module as well as in the panel otherwise the car takes the highest value mileage. Could someone help me modify it in the abs, I have read the 95160 eeprom, the abs also has more than 999,999km, I wanted to put it at 1000km like the picture.[/font]
i have w212 prefacelift with normal key
i want change it to keyless
i search and collect some information
first do i have to change eis ?
second i want to change only the driver handle
i have all modules i need
modules not problem
my next step is
make the car start with pushbuttom
i have new key version 41 and cgdi
change eis or just make new version 41
second i to install n69/5 and driver handle and antena
Hi guys. Im planning to clone above ecu. I assume there is no OTP hence eep and flash swap should do a job however im not sure never done it before and in search engine not too much info. So different tools showing different eeprom size in boot or bench (tricore 1797) one read 96kb one read 32kb i have concerns that it may be bigger than that any advice on topic?
Hi, if anyone can code the blind spot radar on MB w205 2017. The original radar was replaced with a used one, same part number. I have Xentry and Vediamo.
i have read a ecu valeo vd56.1 boot mode
after write file from tuner no communication whit ecu also try whit orginal file no succes
read whit flex magic motorsport some one have any idea or ecu dead
Hello guys, anyone found the JLR PATHFINDER software offline? I saw that they are selling HDD with software installed but no way to find where the software can be downloaded.
Thanks.
Hi, I did a 1.9tdi swap.
My engine is passat 1.9tdi avf, I bought a new ecu.
Now I will do lapping and I want to run without maf.
Can you help me for the file converted from maf to map and egr properly closed?
My vehicle is manual transmission.
question guys got a merc wit crd3.1 it has had dpf egr map on it car is ok starts and drives but when you turn off the lights stay on also when i do it bench i get no id but coms good with diag and a error code p0685 relay 87 anyone had this issue
I have car came without ecu
i bought a used ecu same number bosch edc17c74 but with different software version
i read backup that was immo off, car start but it's in limp mode for lack of coding. (coding is filled with 000000)
now i found a good software backup, but i need to immo off i think, i don't know how to adapt to dash as is immo 6+ and it's not supported by my softwares
Hey, hope yomeone can help me as i dont have a damos file that is the same. I have some that are at some parts identical like KFZWMN maps locations but in my File the maps for fuel cut off like KFTVSA and especially the BBSOTR fuctions are located differently. Maybe someone can help.
Car is MB W205 C43 AMG and it does slight pops stock already.
File and current ols attached.
I need help with Benz w164 with edc17c10 scr dpf egr delete, I had it done with caredit, car runs ok and still the the count down runs on dash and indicate scr count down, possible to get assistance please
Hello, I have this E90 that I suspected the ECU software was tampered with, when I read the ECU I saw that there's a different VIN and HW version recognized by ktag and PCMFlash. Can anybody check if the file I red is original or not, I can't explain myself what is happening.
Hello all members! I broken my tcu while repairing the transmission, I have a backup but when I clone it into another tcu, writting is done but its not responding when I connect it to the vehicle, like the files are corrupted or something like this. I attach dump from bcm2, old tcu, new tcu if anybody can help for immo tranfer. Will pay for working solution Regards
Hello everyone, I am adjusting the mileage of a Renault Laguna 3 that has passed 999,999km, I have adjusted the mileage of the instrument panel to 1000km as if a new panel had been installed, but in this car it is also necessary to modify the mileage in the ABS module as well as in the panel otherwise the car takes the highest value mileage. Could someone help me modify it in the abs, I have read the 95160 eeprom, the abs also has more than 999,999km, I wanted to put it at 1000km like the picture.
I support Programming when replacing a new Unit, used Unit for Toyota Lexus cars (SRS, EMPS, Engine, Rada, ...)
If you want to do it quickly and reliably, please contact me via WhatsApp . I will help you faster.
PRICE : 50$ - 150$ All model Toyota/ Lexus.
CAR INFORMATION:
Brand: YARIS GR EU Year: 2022
Model code: GXPA16L-AGFGZW
[font="Proxima Nova Regular", "Helvetica Neue", Helvetica, Arial, sans-serif][/font]
Information on EPC
[font="Proxima Nova Regular", "Helvetica Neue", Helvetica, Arial, sans-serif][/font]
ECM Part number: 89661-5CD90
[font="Proxima Nova Regular", "Helvetica Neue", Helvetica, Arial, sans-serif][/font]
BEFORE:Many Warning light turn ONand car can not start [font="Proxima Nova Regular", "Helvetica Neue", Helvetica, Arial, sans-serif][/font]
AFTER: All Warning light turn OFF and car can start [font="Proxima Nova Regular", "Helvetica Neue", Helvetica, Arial, sans-serif][/font]
All services are in the attached txt file.
Please contact me via WhatsApp (informations find contact in my profile)
For urgent cases that you need to do immediately (ECU Security, Programming, 12 digit keycode...), if you send a message and there is no response, please call me. I will support within 5 minutes.
![[Image: tjm7FQu.jpeg]](https://i.imgur.com/tjm7FQu.jpeg)
[/font]![[Image: B0JnUKF.jpeg]](https://i.imgur.com/B0JnUKF.jpeg)
[/font]![[Image: JaXhRJ4.jpeg]](https://i.imgur.com/JaXhRJ4.jpeg)
[/font]![[Image: wQbkOqh.jpeg]](https://i.imgur.com/wQbkOqh.jpeg)
[/font]![[Image: D43RxzM.jpeg]](https://i.imgur.com/D43RxzM.jpeg)
[/font]