I have a VW Discover MIB2 Tecnisat Preh device with integrated screen that does not connect to VCDS or OBdeleven on the bench test whit gateway. I have tried in every possible way but the result is always the same, it cannot connect, in VCDS it says “NO Canbus ". To other devices of the same model but with a separate screen that have the device in the glove box I can connect without any problem, but I have already tried at least 3 devices that had everything integrated into the screen but it was not possible to connect to any of them.
I have tried in all possible positions of the rear and in all possible positions with the VCDS connector, I connected one of the models that fits in the glove box and I connected it, then with the same connection plan I try to connect it to the unit with integrated screen and it is not possible... In these units there must be some trick that I do not know about. This happens to me both with devices without navigation with a single SD card slot, and with devices with navigation with 2 SD card slots
If anyone has information on this subject I would be happy to share it.
Hello, i have a Jeep Grand Cherokee with EDC17C79, with original ecu car crank but no start. I bought ecu with same Bosch nr, with this ecu car start and stop. I need transfer immo data from original ecu to donator or IMMO OFF
Hello. Can anyone turn on the gear display in the ZF 6HP 19 gearbox? I now have xhp stage 3 installed, but I have to give it up. I don't have a license. The previous owner has it. I would like stock + gear display .
Hello friends. I need help. Please fix 9402 fault after crash. Who will be so good and kind to clean my eeprom ST95080?
BMW E93
ROC 65779134734-01
eeprom ST95080
Good morning, I need to demobilize my BMW 320d e46 150cv
Someone help me on this topic, I have not found effective information.
I have the ability to read the flash and the eeprom
I need some help... i try 4 different ways to remove dpf adblue and egr
But car goes to limp mode
I need allways have dtc from DPF
Adblue i think is ok
And egr too...
And if anyone can make me a stage 1 in this car it will be nice.
Hello. I have BMW G05 with damaged fuel pump module. I got factory new fuel pump module from dealer and after connection i have error 11B010: Electric Fuel Pump Electronics: Parameter set missing or installation mode active. In esys ECU list i dont have EKPS so I cant code this. What is replace procedure for EKPS in G05?
the original board does not communicate, the car is far away and there is no way to go to it, the technician who changes the board does not have an odis to bind the immo. I really need help from anyone who can!