Hello,
I am new to doing J2534 programming on Nissan. I have Consult III R2R, Nissan directs me to their site to purchase the ECM Blank file. But my ECM is not listed as available option to purchase.
I am doing a USA 2018 Nissan Rogue
The Blank ECU is part number 23703-4BA1B. Does anyone have ECM file for this?
Thank you
Hello, I have a control unit here that needs the correct software to be flashed. Using Vediamo, I have already reset the immobilizer. However, I now need the appropriate software in SMR-F format, as I only have an Openport adapter for flashing. Does anyone have an idea how I can flash a CFF file with J2534 Device ? Vediamo 4 dosen´t work because UDS error.
The software version of the original control unit is 0009023303.
I have a case at the moment forwarded from a mechanic because they don't know how to fix it. The car has rough idle when cold, uses a lot of fuel and has smoke.
Toyota RAV4 D4D 2.2 Diesel, replaced Denso injectors but they have odd values.
First injector set (correction):
3.6 mm3/cycle
0.1 mm3/cycle
-2.7 mm3/cycle
-0.9 mm3/cycle
Second injector set (correction):
0.9 mm3/cycle
-1.4 mm3/cycle
1.1 mm3/cycle
-1.1 mm3/cycle
Are these correction values okay? What is the correct fuel pump pressure for this engine?
bad solutions, bad dpf, bad adblue. I can add a lot of solutions made with this software, many have problems. the support is bad. only 2 updates per year, no logs, nothing
Help me please with right rear tail light wiring diagram, for Porsche Cayenne 92A, EG22, product year 2017, chassis number: WP1ZZZ92ZJLA40057. I need tail light connector pin numbers and the corresponding wire colors, because the connector was broken. Thank you very much!
I am looking for someone who can do Stage 3 on a 2019 Mustang 2.3 Ecoboost MG1CS017. Car has the following mods:
- Pistons
- Rods
- HPFP
- Injectors
- Turbo
- 4bar MAP
- Intake
- Intercooler
- Full exhaust
The owner says that a tuner tried to do Stage 3 but car is jerking a lot at low range and AFR is too rich. I have backup of that file. Can someone do it? Attaching original VR file.
Can someone help make good powerful tune for my winterbeater?
I have tune, but there is idle raised or some maps missed.
I attach both ori and mod.
Need good max tune for this car.
I have installed ODIS-S from forum repositories but if i want to run diagnostics is asking me to login to VW account. can i somehow skip it? for now i would like to use it as simple Audi diagnostic for my car.
