Hi. Fiat Ducato with EDC15C7. Attached is flash 29F400TC read on bench(desoldered). Need immo + chk to be good because the car is far away from me. Thank you.
Hello! I'm looking for a program similar to partslink24 , after entering the VIN number I can identify the factory codes of any car by technical drawing.
I have a Mercedes ML W164 with the Keyless Go option. I recently made a new key, but it does not work with Keyless Go. When using the key, the engine starts but then shuts down, and I receive an error related to the Keyless Go system.
However, when I remove the Keyless Go fob from the ignition, the key works fine.
Is there an aftermarket solution that fully supports Keyless Go? Any advice would be appreciated!
hello some one can help me with modificaction 8hp gearbox ?
im not have experience in gearbox
need
fasters change gear
change set point gear
and gear on display
Hello all i have question , mercedes GT AMG 3l petrol hybryd 2022 , car was accident belt will be new no strong crash nothing but car no start , i mean start and ater 2 sec stop working, no dtc nothing, any sugestiin what can be ?
Hello.
Please dpf off vw Touran 1.6d. EDC17C74.
I tried one solution, after driving 100km the soot is 60g and it smokes. The display shows a dpf error.
Selling a JLR SDD Pro j2534 cable very good quality using branded components & low interference cable so if your looking for a decent cable at a sensible price of £75 this is equal to a mongoose not to be compared to the cheap Chinese ones on ebay.
20 in stock if you are interested please contact me [email protected] can supply it with v167 sdd + key generator and Tools V4.6 all for £75
HI I have a Renault Traffic 3 2018 and I am unable to connect to BCM SRS ABS ECM. No start situation.No dash lights,nothing. ( Vehicle was ok before it was not used for two days )
Tried swapping out BCM with no difference. All lights central locking ect working. Can only connect to a heater module but nothing more. All fuses and power for units have been checked. Also power for bcm has been checked.
Anyone have any ideas of what it could be? Or any test that I can do?
Edit: Dashboard has also been benched and it powers up everything.
I'm new to mapping and wondered if anyone had any thoughts on the new Padflasher 2025 and the software just want to be able to do most common ecm £500 would be my budget
hello friends, got myself a golf and I want to delete dpf and egr (previous owner told me that egr is disabled but can someone check? If not I would need that deleted too
its pcr 2.1 Golf 6
thank you all
Hi my friends could someone reset counter Mb cls w218 ISM module A0002701852 it has error p179D85 and p179D00 and the lock counter is 100 and car not start and no gearbox change,I have read eeprom with vvdi pro and i post .
hi friends, I want to write new km to the cluster on the dashboard. Once I put it back in the car, will there be any problems? What is needed to do it correctly?
