Hello, Please EGR Off for Ssangyong Rexton RX270Xdi DCM3.2
Hi. Please help me to remove the DTC P0400 (Diagnostic) from this dump!
The EGR is removed from the car physically since years but now the P0400 error constant.
Model of Airbag: 0285012268 for Volvo V40. I had a no communicating srs module that I changed with used one, physically swapped eeproms and then it gave me the U3000-00 error in srs and U0452-86 in ABS. How can I solve this problem? I have attached pictures of airbag module, errors and eeprom file. Thanks.
perhaps anyone able to check the CAS3+ EEprom file for correct ISN i program with Autel. Car start but P2F49
Manipulation fault.
I changed ECU with used one (same number). What to do?
13 month ago i have buy the basic version from KT200 2023.
I am use latest software 2023. Interface have work with not many problems but started anytime and i could work with them.
Now the problem. When i want to start the software, Software not open. Try to load but after 25% stop and shut down.
I don't hear the relay clicking. normally if i connect, relay clicking and when starting software relay also clicking many times.
Now nothing. Same also if i don't connect interface to PC. Software does not recognizes the interface connected or not no matter.
Try to open KT200 Interface but see nothing burned or anything else. Seems to be ok visual.
Try to install software on 3 other PC's but does not help. Try different server, reset interface. Install driver. Also try another online communication.
All does not help.
So relays does not clicking could be that relay is broken? I have order new Omrom Relay want to try replace it but i don't know if it could solved the problem.
Maybe someone have the same problem and a solution.
I would love to learn how map optimization works, with tutorials and examples where you can see what exactly was changed in the map etc.
Unfortunately I can't find anything on the internet that I can learn, so I wanted to ask in this wonderful forum how you do it or how you learned it and if you could help me somehow?
I bought a Kess v2 clone to flash and it has worked so far for reading and writing but I would like to take a lot of time to learn it myself.
I know that there are courses offered by e.g. Alientech but unfortunately I don't have the budget for this as it's not that cheap.
I did service reset on a4 b9 with Launch (usually I do it with Odis).
After service reset I get service notification every time I turn ignition ON and OFF.
So service interval is resetted but I get warning Service in 15000km...
Tried to reset with vcds, odis after that. Battery disconnected for 20min... Still same.
Anyone know how to get rid of notification every time on ignition?