Hallo Everyone
Is there someone who can code this as a car without tire pressure sensors?
Because I placed wheels without sensors and I have warning on dashboard.
I have sm2 cable maybe someone can code it with teamviewer?
Fault code 124D:02-8A : Tire pressure sensor
Thanks in advance
Hi all friends. I have this radio blaupunkt installed to alfa romeo. The model of radio is alfa connect gta. I have try the code 4841 but not working. Is possible to help me? Thanks
got a bmw f1h f40 year 2024 some one before me increased the milage with +2000km but in kombi in the midle is blank now and also the picture in dah of car isnt a 1 srie but a x5 or something
i dont know how they increased it but i trued to program and code it with ista online but no luck
I have problem with KIA Sportage 2013 ESCL. I must to change steering lock, I have used one from another car but it's not neutralized and I don't have vin/pin from this one. Maybe have someone some option/solution to neutralized or virginized escl from dump?
Hi,
Van had complete ecu kit fitted.
Airbag light on, caused by passenger airbag fault saying not configured.
Go in with Renolink but it doesn’t let me configure?
Any help? Thanks
I am in need of ori file for a 1.8 petrol Opel Insignia.
ECU is AcDelco E83, AAFZ, 12634556, Serv No: 12621466
I did a bench read using foxflash but I don`t think the ori read was a coplete read. I got the file modified and written back to ecu after that the car will not start and it will not detect the ecu. Did a new write using the ori file but still the car don`t start and will not detect the ecu. Therefore I suspect that the foxflash did not do a successfull read of the ori.
Also, I only did a flash read.
Hello , i have a mb sprinter 2.2Diesel, 2014 .Problem is no pressure in intake manifold wan dont have a power... , all soleboids on turbo , low pressure and high pressure turbo controls work propertly, all hoses and intercooler are ok, and no check engine light in dash, so i decide , maybe its flashed , and not done correctly , and thinking about egr , he have a sensors on on egr pressure ( from exh manifold to egr) , so i change it but no effect....
Hello. I have a Launch X431 Diagun which one im trying to fix after buy from previous owner. I'm missing two resistors next to K9F1G08U0C, and tester wont start. Can somebody please tell me value of resistors, or open your own x431, and measure it for me? Searching internet for 2 days, totally nothing found. Launch support cant help also.
