Hi could someone help me with a customers car, Its a 2013 mini roadster with an active Rear spoiler. We have the warning on dash and DTC's stored for the spoiler hall sensor. Its worth mentioning that the SPEG has been repaired for the fuel pump relay and this fault has come about around the same time however the spoiler was left half up for many weeks but it did go down and now wont move at all.
I have checked the fuse which is ok
I have stripped the harness by the tailgate hinge and all wiring appears good.
I have checked connections at the spoiler and i have all voltages i think are correct.
The problem is i cant seem to find a decent wiring diagram for this to see which plug at the SPEG the hall sensors are part of.
I dont want to guess at a spoiler unless iv proved it.
Hi. i have read EIS data, and have a replacement CRD2.35 read by boot.
Ori CRD2.35 gone.
What is needed to program ECU?
Can be done with Xhorse pad? IM608?
I dont have vehicle, only EIS & ECU and 1 working key.
I assume VIN and SSID & other??
Last week got one audi c8 for AdBlue off. The car was 2020 so when flex displayed a error message that the ECU is locked and can not be read on bench, I thought it is about the production date of the car beeing above 06.2020.
Today I got A6 2.0tdi for AdBlue again, but this time model year 2018 but FLEX again gave me the error that ECU is not readable on bench again. So I took KESS3 and connected the ECU and I was able to read it normaly. I was reading that ECUs normaly beofore. I used FLEX V2 and both times the last version of software.
Somebody encountered the same problem? I did not try to read it with V1 via browser.
Hello need need Stage 1 170HP, AdBlue and EGR off WITHOUT EGR disconnect. I have only solution with egr disconnect it is possible without disconnect EGR?
Hi!
I have an issue diagnosing B1A7F-00 fault. It does clear, but comes back after ignition cycle. Car cranks, ignition goes on, dash lights up but won't unlock the steering wheel.
I found the thread regarding fuse, my its not blown. Checked the erths, they all fine. I don't have wiring diagram.
Would anyone be able to help me fixing this problem?
Hello,
I have 722.9 vgs 4.4 tcm . This tcm have y3/8n1 and y3/8n2 sensor fault . Can we replace to this sensor like other 722.9 tcms ? If available where can i order this sensor ? Thanks regards,
MIB reboots approximately 3 mins, it doesnt metter what i choose radio, navi or anything
first diagnosis 5F module :
U11B800 - external media interface without communication (sporadic)
U10CC00 - optical databus of digital audio system (sporadic)
U111100 - limitation of functions due to lack of response (sporadic)
after clear no DTCs
updated at vag dealer and still problem
