Hello. I have a Launch X431 Diagun which one im trying to fix after buy from previous owner. I'm missing two resistors next to K9F1G08U0C, and tester wont start. Can somebody please tell me value of resistors, or open your own x431, and measure it for me? Searching internet for 2 days, totally nothing found. Launch support cant help also.
Hello everyone.
Patient Jaguar E-Pace 2020year
The car came for Airbag programming.
The original Airbag module was damaged by the previous workshop (no communication)
The customer bought an Airbag module with the same numbers (used) and now there is a problem with coding.
I mainly deal with the Ford brand, the Jaguar brand is not well known to me.
That's why I'm looking for help here.
I know that there is someone here who has skills in programming the Jaguar brand.
Please help.
Good morning, I have a problem with a 2011 Nissan Qashqai, I didn't read the manual correctly and I didn't save the injector coding, now it has the p0611 fault and won't start
I have found the injector codes but I don't have a way to write them. I have read the injector file that it gives me with kess 3 but I don't know how to modify it, can someone help me?
Hi. It is necessary to make the mileage on the dashboard the same as on the bsi and dump dashboard.
check file for correctness or error bad..
Two File BSI Nec orig and Nec 0km correct ok ?
PIN CODE BSI: 5RCX
One File dash Eeprom 93C66 x16 278.304 km certified kilometres ok should be modified or not ?
do not touch programming olny dash
TachoSoft231. I don't understand you tachoSoft very much if you need to modify eeprom 93C66x16
Car type: Citroen Xsara Picasso - (Dash+BSI) - 2001-2003 years
The mileage is stored in the next lines:
Dash manufacturer is VDO, BSI is made by Valeo
Dash chip type is 93c66, in BSI you must find NEC 78F0949
0000: xx xx ED F0 DB E1 B7 C3 6F 87 DF 0E BF 1D 7F 3B
0010: FF 76 F0 ED E1 DB C3 B7 87 6F 0E DF 1D BF 3B 7F
0020: 76 FF xx xx xx xx xx xx xx xx xx xx xx xx xx xx
all shown bytes is a mileage
I hope someone can assist me with a problem I've been experiencing. I recently noticed that the passenger map light in my A8L D5 has started to turn on and off intermittently while I’m driving. Additionally, the brightness fluctuates between high and low on its own, without any touch as i am holding the light.
When I try to turn it off, it won’t switch off till i press on the light multiple times, even after pressing on the light. Then, after a while, it turns on again. I have a retrofitted ambient lighting module connected to the CAN network, but I don’t think that’s related, as the module has been in place for a long time without issues.
Typically, the red light is set to stay on, so it activates when I open the doors or remove the key from the ignition. It’s strange that this behavior has started now.
If anyone has any insights or suggestions, I would greatly appreciate your help!
Hi all, I need new km on 93c76 range rover sport 2014. old value 261300km, new value 191300km. My programmer reads me as 93c76 two file possibilities, one normal and the other x16. thank you
Hi, I got problem with peugeot 508, first time that it was in my shop I did calibration and it was vertical 0.5° and horisontal 0 after everything. After 2 weeks customer said that radar miscalibrated on highway, nothing was hitted. I did calibration that second time and again everything was fine for 1-2 weeks.
After that I got same miscalibration fault and changed radar with second one / used one, did calibration again 0° horisontal 0° vertical after driving and guess what, after 2-3 weeks miscalibration comes back. Did some of you got same fault or something like that because there is something wrong with it.
hi i have a 2013 vw caravelle 2.0 tdi 140hp and i i need a ori file for this ecu .... i cant read this ecu obd bench or boot and i need an ori file please
03L906019JN
EDC17CP14/20
9978
H37
