Hello members, im trying to off adblue sistem on fiat ducato 250 2019 , all automated solutions failed , i perform all resets without inject ( cant reset) on mod file, any help will be apreciated :
hw001
ecu sw nr : D140A751
sw vers : 0051
52127147
Hi all,
I have this Ford Grand C-Max 2011 with Fuel Pressure issue. It has no In-Tank Diesel lift Pump but the Car's wire harness made provision for it with a 12V IGN and Ground
Is it right for me to install Pump?
Will it eliminate Air leak and Priming/bleeding activities?
hello everyone
I have a citroen ds5
will anyone be able to help me with a virgin file for a new continental Q04 bsi because old it came with a bad eeprom read and no ignition....actually nothing. I attach the files from the old and the second use with the same numbers. I was only able to transfer the vin number
Hi people,
I have problem with hill holder function on my wife alfa romeo mito.
When function activated on hill car stuck and its very hard to go again.
I was go to alfa romeo delership and mechanics change and test many parts, but no this function stuck every time on hill.
I have kess v2 and read ECU file. Can someone help me with delete this function from car ECU.
Hello guys. I've read this faulty Ecu with Ktag(2.13) ,(made a backup) and unlocked it. When I want to read it, and save it with Kess (5.017, CAN ,OBD), it gives me Ckecksum Error. So I dont have read after unlock, just the first backup with Ktag. Both of these tools are chinese clones, is that the reason? I also got second hand ECU with same part number, and its unlocked with the same Ktag, but Kess wont give me file to write it there. It just pops up "checksum error" ,when I try to save the file. Can the checksum be corrected from the backup what I read with Ktag? Or is there any other options?
Hello, i have succeded to read D flash, generated eeprom, but when write eeprom, at check the file does not match with my eeprom file. Someone told me to write partition but i cannot find it in smok prog. Did someone used smok Prog to repair frm?
Thx!
I would like to get ONE IF for E39, E46, E60, F10, F20, G30 and thinking of buying a BMW ICOM NEXT A,B,C to finish all my needs. I'm working with DCAN-USB-Cable, doitauto IF for OBD2 for INPA as well, but the goal is: One Set to get rid of this rubbish connections .
Now there are Clone-IF as well, Original ICOM Next is 700€ and the needed parts for B, C 300€. A Clone-Set will cost 340$ from obdii.shop with WiFi.
I have ECU 0 281 010 205, have been doing immo off in 24c04 eeprom using cracked AE tool and immo killer, compared files, both tools did same job, write to eeprom with verify was successful, cables at EWS are bypassed, car cranks but no start, DTC in DDE is that there is problem with immo, don't remember exact DTC.
any idea what else can be done ? attached are original and mod eeprom from ecu/dde 24c04 eeprom.
hi
I need a starting diagram (50) mercedes Vito w639 109dci year 2008 vin number wdf63960313306080 it doesn't start, but if you activate the relay it starts the engine turns but doesn't start
Turn on the ignition and unlock the steering
synchronization?
thanks
![[Image: 689df490bc3f47c7ee0c02b370ff1c40.jpg]](https://uploads.tapatalk-cdn.com/20241222/689df490bc3f47c7ee0c02b370ff1c40.jpg)
.