Hello! Iam running autocom 2020 at the moment ,works great but sometimes i want older like 2016,2017 , i have running it before on win 10 whitout problems.
Now i cant them to work ,just the 2020 model ,
When i try to start main.exe it just says " Error , Failed to initizialite logging"
need some advice on Fiat 500X 2015 with Ecu EDC19C69 after eeprom lost on steering lock and a virgin adapted and proxy alignment
i have the +15 now car crank but no start this dtc on ecu U0168 00
car has 2 keys same problem with both
try to delete keys and write back but same result what do you think ? thank you for advice
Hi I’m looking for someone who can do a full delete on a 21 duramax suburban all my usual avenues say it can’t be done I’m located in Alberta and hope to find someone on here to do it or someone on here who works with someone in Alberta anyways please pm me
Hello,
Possible check it if correct removal DPF on toyota yaris 1.4 d4d inside edc 17cp37 bosch: 0281031060 and toyota: 89661-0DQ30, sw: 1037531475.
Thanks.
good morning everyone. is there any expert in siemens ms42 bmw e46, who can help me to remove the ISA mechanical fault of the ICV (error 211 (D3)) I tried to disable the isa1 and 2 faults but the mechanical dtc remains.
Hi, I have an ECU EDC17C10 of a Ford, which I can read perfectly but I can not write in it because I get password error, in bootmode I can not even read it, the case is that I have the password, but I do not know why I can not write in the ECU, could someone help me?
I have a 2018 F550 with M300 dana rear end. I'm looking for the procedure to the set the pinion and ring into the housing. We had to take it out and get axle machine for bad spindle.
I'm having a hard time trying to find manual for axle.
Hello to all. I have problems with 2008 2.0liter nissan petrol idle speed. Many times saw situation when idle speed jumping. Need to disconnect at least two ignition coils and try other tricks to reduce engine speed and make idle speed adaptation... Always shitty stories after throttle clean on theese models.
But this time something strange. Customer changed throttle valve and later ecu also. I cant run away from jumping idle speed. No vaccum leaks at all. No dtc in memory. Engine in operating temperature 70-90 degree celsius. All loads off. When i start adaptation idle speed imeaditelly drops to 700rpm. Scanner shows -succesfully completed. But after engine restart idle speed jumping again! If i press accelerator pedal after adaptation - engine goes off.
One moore strange thing. If i press accelerator pedal on ignition with engine stopped - fuse box underhood clicking. Esp lights starts flashing on dash. Engine light goes off. With accelerator pedal realised clicking noise stops. Esp light goes off. Engine light turns on again. And fuel pump works for 5sec. Seems like ecu restarting after pedal.realised. But this happens only on ignition position. With engine running no clickink sounds or other strange things. Throttle valve moves only when engine running. On ignition position throttle valve has no reaction to accelerator pedal.
Has anyone seen it before?
Thank You
Possible that idle lerearn not working after immooff?
