I need help with a very common Renault issue/fault regarding the adblue module.
This need reset or repair counter for adblue tank. There is no fault in system and the tank is new. Diagnose method to reset i believe doesnt work therefore i only got the DCU unit here.
Renault Master
0281034701 (DCU17PC42)
DCU module / SCR Module.
Can someone help with this please? I can pay for the help.
[font="MHH Font", Calibri, sans-serif]i hawe fault -eeprom error.car work with them.but i try write injector codes.now car wont start.same fault.i read full bdm ecu.ecu is denso 89661-42j11 275900-2601 on case. on green plate is 275922-022. processor is 76f0085... i need full bdm read ori?[/font]
Hello,
Can someone help me with a faulty EGR solenoid to make EGR OFF ?.
Van is Toyota Proace MY2020 2.0D.
Van has already adblue solution.
Thank you so much!
Hi there
Can someone please help with incodes for 2016 ford ecosport?
OUTCODE for IC
0000-36C141-000000
OUTCODE for PCM
0000-FFBA4B-000000
Thanks in advance
I did several tests but I couldn't do pops, only rev limit.
Is there anyone experienced who can help me with a decent map and limit to 4200 rpm with pop?
I'm ruining myself in eeproms. ç_ç
Supported key blades: HU64, HU101,HU66, TOY43, HON66, DW04R and much more
Product Features:
1. Supports 4D 8A 4A chip types
2. Supports 213-434MHz
3. Supports buttons and frequency modifying
4. Reusable
5. Support emgergency start
6. Support add key and all keys lost
Hello! I have a 2005 Renault Trafic 2.5 dci with a burned original ECU, after fixing the engine wiring I installed a second-hand ECU with the immobiliser disabled, but it has many errors, I think the software is not the same.
I tried loading the original flash into the "new" ECU and the vehicle does not start, I think the file is damaged, the original eeprom was unusable due to the fire.
I am attaching what has been recovered from the original flash + flash and eeprom from the replacement ECU.
Can anyone help me fix the original file or find a file with the correct software?
I’m having a issue with a Volvo with Denso vea ecu 2.0d dpf off iv tried about 6 different soloutions and I either get dpf light on the dash or eml or it smokes like to the point you can’t. See behind you unless you unplug temp sensors but it gives eml but no codes
Hey everyone hopefully someone can give me a hand.
I need to program a used FEM module on a 2014 bmw 328i F30. The original FEM is damaged can’t read the eprom chip. I would like to know what tool would you guys recommend for this job vvdi bim or cgdi bmw?
Is anyone able to remove the immobilizer from this ECU?
I can't clone it as the old ECU is completely damaged.
If someone can help, I'm waiting for information, and I will send the file.