Recently i been seing a lot of advertiseme't on facebook for magic solutions..
Wich upon check propperly IS NOT FROM MAGIC MOTORSPORT !
So first of al looking to come acros some People who have purchased and tested this new software/program out even if it was just short term.. i see they offer annywhere from 1 month upto 1year and renewing that later at lower cost. Wich seems al fair .
now regardles of who made this software.
Is it actually any good.. ?
Or just another copy of other DTC softwares with bad support and bad solutions.
To sum it al up..
1 is it worth the money ?
2 is the software any good / reliable to use on a lot of different ecu's old and new.
3 how is the support if stuf does go bad ?
4 from ur experience with it do u recommand to give it a try at least for a month.. or is it so good that a year subscription is simply a no trainer and the way to go...
Maybe if it's actually really good we can ask for a group buy i see they offer like 2pc's for Big discounts.. like 50% off basically. wich some of it may even almost look to go to be true 🤔
Curious to hear what everyone has to say
Kind regards AMT
Made software update on G21 with ESYS Ultra, after TAL calculation everything was fine, HWEL was black for KOMBI, but it got error while programming and now KOMBI is accepting only BTLD and further it is not working. KOMBI is not working, only green arrows flashing all the time
I have heard somewhere that dying G series clusters are pretty often
Hello. VW Passat B5+ 2001 arrived. 1.6 with a complaint of poor starting when cold. According to the client, after repairing the head (Replacing the cylinder head gasket), after some time the car starts poorly on a cold start, bad starting is consistently included in the air filter and can stall, but after several methods the car starts normally and runs cleanly when warmed up. The client changed the pressure regulator, fuel pump, and spark plugs. All to no avail. Compression check when cold 12, fuel pressure 3.5-4 bar, air leaks checked and fixed, timing marks checked, injectors are also ok, crankshaft sensor, camshaft sensor and air flow sensor were changed... Coolant temperature sensor shows real temperature. Another firmware was loaded, everything is the same. There are no errors in the engine. There is an EGR, tomorrow I will shut it off and check the exhaust system. Please tell me, maybe someone has encountered such a problem? Where to dig next? Thanks in advance!
Hi all. Wanted to reach out and ask for some help. Have replaced the steering rack in a Mercedes W222, had an accident and the original steering rack was damaged. The steering rack I purchased looks exactly the same but has a different part number on it. Replaced the rack and the power steering is not working and I am getting the following message.
Is there anything I can do to make the new steering rack work? Thank you in advance for your help.
Can't start the car...have run diagnostics with VCDS...this is what i get:
Quote:Friday,25,October,2024,07:05:52:00009
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 8 x64
VCDS Version: 24.7.0.0
Data version: 20240715 DS356.3 www.Ross-Tech.com
-------------------------------------------------------------------------------
Address 01: Engine
Cannot be reached
-------------------------------------------------------------------------------
Address 02: Auto Trans (J217) Labels:| 0CM-325-025.clb
Part No SW: 2H0 927 158 D HW: 0CM 325 025
Component: 2H0 20RTDIRdW H19 3001
Revision: --H19--- CVN: ABDE511D
Coding: 000001
Shop #: WSC 00000 000 00000
ASAM Dataset: EV_TCMAL450211 002011
ROD: EV_TCMAL450211_002_VN81.rod
VCID: 2E53BBBF71174CE661-807A
2 Faults Found:
12554 - No Communication with Engine Control Module (SAE ECM/PCM)
U0100 00 [10100111] - -
MIL ON - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Priority: 6
Fault Frequency: 1
Mileage: 417403 km
Date: 2024.10.25.
Time: 01:50:23
Unlearning counter according OBD: 40
Voltage terminal 30: 11.655 V
Engine RPM: 0 /min
Status data bus communication diagnostic interface-State ACC_Radar received: not received
Status data bus communication diagnostic interface-State Airbag received: not received
Status data bus communication diagnostic interface-State BATMAN received: not received
Status data bus communication diagnostic interface-State Deashboard received: not received
Status data bus communication diagnostic interface-State ECM received: not received
Status data bus communication diagnostic interface-State ESP received: not received
Status data bus communication diagnostic interface-State EZS received: not received
Status data bus communication diagnostic interface-State Gateway received: not received
Status data bus communication diagnostic interface-State NIVEAU received: not received
Status data bus communication diagnostic interface-State Parking Brake received: not received
Status data bus communication diagnostic interface-State Steering Angle received: received
Status data bus communication diagnostic interface-State Steering Assist received: not received
Transfer speed by dash panel insert: valid
Transfer speed by dash panel insert: 0.00 km/h
21613 - No Communication with Engine Control Module (SAE ECM/PCM)
U0100 00 [10101111] - -
MIL ON - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Priority: 6
Fault Frequency: 1
Mileage: 417403 km
Date: 2024.10.25.
Time: 01:50:23
Unlearning counter according OBD: 40
Voltage terminal 30: 11.655 V
Engine RPM: 0 /min
Status data bus communication diagnostic interface-State ACC_Radar received: not received
Status data bus communication diagnostic interface-State Airbag received: not received
Status data bus communication diagnostic interface-State BATMAN received: not received
Status data bus communication diagnostic interface-State Deashboard received: not received
Status data bus communication diagnostic interface-State ECM received: not received
Status data bus communication diagnostic interface-State ESP received: not received
Status data bus communication diagnostic interface-State EZS received: not received
Status data bus communication diagnostic interface-State Gateway received: not received
Status data bus communication diagnostic interface-State NIVEAU received: not received
Status data bus communication diagnostic interface-State Parking Brake received: not received
Status data bus communication diagnostic interface-State Steering Angle received: received
Status data bus communication diagnostic interface-State Steering Assist received: not received
Transfer speed by dash panel insert: valid
Transfer speed by dash panel insert: 0.00 km/h
Subsystem 2 - Part No SW: 6R0 959 802 M HW: 6R0 959 802 M Labels: 6R0-959-802.CLB
Component: J386__TSG_FT 002 3323
Serial number: --------------------
Coding: 150000
Subsystem 3 - Part No SW: 6R0 959 801 P HW: 6R0 959 801 P Labels: 6R0-959-801.CLB
Component: J387__TSG_BT 002 3323
Serial number: --------------------
Coding: 150000
Subsystem 4 - Part No: 5C0 951 171
Component: Sensor, DWA 0 005 0502
Coding: 000000
Subsystem 5 - Part No: 1K0 951 605 C
Component: LIN BACKUP HO H05 1501
Coding: 000000
Subsystem 6 - Part No: 5C0 951 171
Component: Sensor, DWA 0 005 0502
Coding: 000000
Subsystem 7 - Part No SW: 2H0 959 442 HW: 2H0 959 442 Labels: 3C8-959-537.CLB
Component: E221__MFL-DC1 H01 0103
Serial number: 29150001741620105364
Coding: A4FFFF
Subsystem 8 - Part No SW: 6R0 959 811 D HW: 6R0 959 811 D
Component: J388__TSG_HL 002 3323
Serial number: --------------------
Coding: 100000
Subsystem 9 - Part No SW: 6R0 959 812 D HW: 6R0 959 812 D
Component: J389__TSG_HR 002 3323
Serial number: --------------------
Coding: 100000
3 Faults Found:
00967 - Left Turn Signals
006 - Short to Plus
Freeze Frame:
Fault Status: 01100110
Fault Priority: 2
Fault Frequency: 13
Reset counter: 93
Mileage: 417403 km
Time Indication: 0
Date: 2019.03.18.
Time: 01:50:25
03591 - Control Circuit for Horn
006 - Short to Plus
Freeze Frame:
Fault Status: 01100110
Fault Priority: 3
Fault Frequency: 13
Reset counter: 93
Mileage: 417403 km
Time Indication: 0
Date: 2019.03.18.
Time: 01:50:27
02745 - Bulb for Daytime Running Light; Left
010 - Open or Short to Plus - Intermittent
Freeze Frame:
Fault Status: 00101010
Fault Priority: 3
Fault Frequency: 5
Reset counter: 133
Mileage: 417403 km
Time Indication: 0
Date: 2019.03.18.
Time: 01:50:24
-------------------------------------------------------------------------------
Address 10: Park/Steer Assist (J446) Labels:| 7E0-919-475.clb
Part No SW: 7E0 919 475 L HW: 7N0 919 475
Component: PARKHILFE 8K H06 0106
Revision: -------- Serial number: 28231521200223
Coding: 318103
Shop #: WSC 16174 002 1048576
ASAM Dataset: EV_VW75XParkAssis8K 001003
ROD: EV_VW75XParkAssis8K_001_VN81.rod
VCID: 3B7582EBB265A94ED6-806E
No fault code found.
-------------------------------------------------------------------------------
Address 15: Airbags (J234) Labels:| 5K0-959-655.clb
Part No SW: 2H0 959 655 B HW: 2H0 959 655 B
Component: VW10Airbag00H H07 0013
Revision: -------- Serial number: 003HN00MWE0P Dataset Number: 2H0003v____ 0162
Coding: 000000000000000000000000000000003048
Shop #: WSC 07446 790 50316
ASAM Dataset: EV_AirbaVW10BPAVN750 A01026
ROD: EV_AirbaVW10BPAVN750.rod
VCID: 3365AACB9A35610E0E-8066
Crash sensor for side airbag: driver side:
Serial number: 3495RRB40533626UK8HI
Front Passenger's Side Airbag Crash Sensor:
Serial number: 3505RRB40593IB886P8B
Crash sensor for front airbag: driver side:
Serial number: 3555YRB401E54QJ699BQ
Crash sensor for front airbag: front passenger side:
Serial number: 3565YRB401454QJ6698B
No fault code found.
-------------------------------------------------------------------------------
Address 17: Instruments (J285) Labels:| 5K0-920-xxx-17.clb-SRI1
Part No SW: 2H0 920 871 B HW: 2H0 920 871 B
Component: KOMBI H04 1009
Serial number: 00000000000000
Coding: 151E000000
Shop #: WSC 07456 790 50316
ASAM Dataset: EV_Kombi_UDS_VDD_RM09 A05730
ROD: EV_Kombi_UDS_VDD_RM09_005_VW31.rod
VCID: 275D4E9B5EED1DAEA2-8072
2 Faults Found:
12648448 - Function Restricted due to Missing Message(s)
U1111 00 [00001001] - -
[New feature! Extended UDS fault detail is only supported by current gen. interfaces]
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Priority: 6
Fault Frequency: 98
Reset counter: 93
Mileage: 417403 km
Date: 2024.10.25.
Time: 00:00:30
12648704 - Function Restricted due to Missing Message(s)
U1111 00 [00001000] - -
[New feature! Extended UDS fault detail is only supported by current gen. interfaces]
Intermittent - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Priority: 6
Fault Frequency: 1
Reset counter: 133
Mileage: 417403 km
Date: 2024.10.25.
Time: 00:00:11
I'm trying to make a simple tune to get the famous Rallye Sound or Boosted Launch. Already set the torque ramp to high values during launch control but still there's no Boost during Launch Control. Is anyone willing to help or do the file service?
Willing to pay.
Hello, can someone help me with an components diagram on mercedes om256 mg1cp002? It has some coil driver issues because of damaged wiring harness. Thank you!
Hello everyone.
Im looking for original ECU file for Volvo XC70 2007 P2 2.4D5 Bosch EDC16C31. I'm attaching bin file.
I've bought the car and someone mess with ECU, so I don't know if EGR, DPF are off (maybe someone kindly will have a look)
I would like to flash original file and test the car by my own to return parts to original state.
Thank you in advance.
I'm have a matco maxflex bought from pawnshop they factory reset it has the pin code and serial# but was unaware of receipt code which I don't have.called matco it's not stolen but of course it's still registered to a dead guy. What are my options.cab it be turned in to a x431.
![[Image: Capture.jpg]](https://i.ibb.co/d509f5Z/Capture.jpg)
