I'm diagnosing an issue with crashed 17 w213 E220d, multiple airbags/seatbelts deployed.
Engine ECU has an active B1C3200 Control unit 'Supplemental Restraint System (SRS)' has detected a crash.
Tried multiple times "Enabling engine start after crash event" but it always ends up in an error.
Am I supposed to find a way to clear OCR module first? Or it shouldn't really matter and enabling engine start is supposed to clear B1C3200 from engine ecu?
Volvo XC90 2020 from USA. I have no communication with RML and RMR module. Anyone know where this module are? I have DTC in SRS U0140 - communication with CEM, in ASDM I have two DTC about communication with RML and RMR.
Hello everyone..
I have an airbag control unit from a Fiat Ducato. DWG 01393755080. OBD says internal error. I read the EEPROM. Can someone reset it and send me the cleared file back?
Hello i would like to replace destoryed BMP M054 for BE9077 but display show error message about not installed unlock key. What can i do for it to work? SW update? Which one? thanks a lot
I have one opel vivaro 2017-2018 come to my shop and i cant figure out whats going on.
0 fault codes on all ecu’s in car
633km Failure anti pollution stays all the time.
Car driven 60k km
Checked various sensors all the sensors seems to be in range checked via live data and visually/ physically resistance etc…
Adblue level 100%
Only one thing which is catching my eye is the front mirror ambient temperature sensor measuring 5k+ ohms should be in range 0-255ohms (tried to warm up sensor to reach 255ohms, on 60C is shorting out and goes mad with ohms)
Also different pressure sensor voltage stays 0 always, when unpluging sensor fault code on ecm appears.
Hello, anyone have solution to working RDS in usa unit ? i change coding with forscan but still have problem with RDS
here is my actual codding in ACM and APIM
I have got one Audi q7 2013 with failed column lock, have seen that I have to clone it, currently my only IMMO/key tool is Autel KM100, willing to buy something to be able to clone steering lock data, any recommendations for best value tool ?
Hi, attached is my file which has been provided by my regular file provider.
ECU was only sent to me, I dont have car, customer states that issue with hot start still persist.
anybody willing to check if the hotstart has been fixed ?
hard discussion with file provider ( time to change)