REMOTE AdBlue Reset SERVICE without FLASH ecu or DCU Renault SID321 MD1cs006 MD1cs016

RESET Adblue withtout any error on dashboard

NO NEED FLASH   Ecu or Dcu
is not START authorisation solution
is not for 1 time start
is not by renolink or by bena
is OUR DEVELOPPPEMENT

we can work with your  any passthru J2534 or ELM interface
service is Very Fast

contact by PM

I have passat cc 2.0 TSI 2012

The car cranking but not starting

There’s no engine light on instrument cluster but if i disconnect ECU , engine light working on instrument cluster

I check with OBD scanner There’s no fault and there’s communication with ECU

I check OBD port can resistor can bus 60 ohm

I checked sensor there’s 5v supply from ECU

I check 12V supply to ECU there’s no any problem

I hope you can help me

Hello everyone,
I have installed the injectors from an EDC15 150Hp (ARL) in an EDC16U34 105Hp.
Delivery time also taken from EDC15.
So far, it's running quite well, but the start of injection doesn't fit yet.
Does anyone here have experience with this?


lg.

Attached Files

Skoda_1.rar

2

53.24 KB

Download

Hi,

I have an issue with the remote control doesn't work the RF  on a w176 from 2017.
I have dtc on N69/5 keyless go 'open circuit for the antennas' keyless go and the A2/18 antenna amplifier .

I believe the keyless entry antenna are missing (4), at least the both door handle are not with antenna.
But my problem is the normal RF opening and the antenna amplifier: A166 820 06 89. (The client doesnt care about keyless entry)
when i run the antenna test on keyless go module it will return dtc as open circurit, the conection with the antenna is ok, but i don't think the antenna is working.

I've attached a printscreen with the waveform from the antenna output when i'm pressing the remote buttons and there are no changes ...its a PWM 50% duty and 108Hz.

Attached Files

Thumbnail(s)
   

Hi,
I have an Mercedes OM648 that I'd like to tune. I have read FLASH from OBD with MPPS V18 and have successfully found most maps as no DAMOS for this car that I can find. I want to backup the ECU in-case I mess it up. 

What tool do I need to make a full backup for this ECU?
Can this be done without opening the ECU? I have it removed from car.

A 648 150 04 79
CR3.43 3.2L
FD 03M11
HW 43.02
SW 44.03

Can MPPS do a full read if I go directly to the pins? Can Kess do this without opening the EDC16C2?
Thank you

Hi

I have broken mech unit 8E5910155H, hw 01J927156HT. 

They fitted 8E2910155G, hw 01J927156JK

Is somehow possible to make it work? I tried flash it with odis e but no luck

vin WAUZZZ8E98A102093

Someone has Original file for Mercedes-Benz S63 W222 ECU File readout with bench?

SW Version: 0009040600 1579021300 1579039400
Calibration File: 8A45760U83B0000 2102
Calibration: 1579039400

We need original file with Full Software Block (Flex Bench, AutoTuner Bench, Kess Bench)

Hi, 
Can someone help to immo off this ECU
BOSCH-0261S02112
3C0907115
BENZIN MED9.1

Attached Files

[email protected]

2

919 bytes

Download

Hi, I'm trying to load SR 4.2 on a WIN10 Pro machine, I do have the keygen and SR loaded into a WIN7 machine and can get the keygen to load up, but when I hit get SN, I get license error in the box. I've searched here and found a couple of posts about it, but no solution, anyone have a fix? Thanks

Hey, i just made SVRL limiter at 4500 for my van. But i want black smoke at the limiter, any ideas of how i can do this? File attached if anyone feels the urge to help me

Attached Files

WinOLS (CS OK VW Transporter (vwt5aj61291HARDCUT) - 372365).zip

1

282.02 KB

Download

Hi guys,
Do you know which version can I swap for 0am927769K? Or a compatibility list? Many thanks in advance!!

Enviado desde mi 2210132G mediante Tapatalk

Hello, 
who can make me an IMM OFF with checksum 
as read with Batronix BX48 the Flash

Siemens SIMK43  
5WY1963B
39171-23270
AM29F400BB

Attached Files

Hyunai Tucson SIMK43 5WY1963B org 29F400BB.rar

3

153.07 KB

Download

Hello friends,
Can anyone make key files for me from EIS dump ? Key is with nec chip. Number end with .021. I have dump readed with R270.

Thanks in advance.

Attached Files

eeprom r270.rar

3

916 bytes

Download

hello anyone have good solution dpf off ?
davinci wont working

Attached Files

corsae98.rar

2

1.15 MB

Download

Needed Vag MED17.1.27 DAMOS, can someone share? any sw version will be very helpful.

Hi everyone,
Can someone remove LAMBDA from this file?

Thanks in advanced.

Attached Files

ORI_IntFl.rar

5

624.48 KB

Download

Someone has Original file for Mercedes-Benz S63 W222 ECU File readout with bench?

SW Version:   0009040600 1579021300 1579039400
Calibration File:  8A45760U83B0000 2102
Calibration:    1579039400

We need original file with Full Software Block (Flex Bench, AutoTuner Bench, Kess Bench)

could I ask for the checksum in my stage 1 file, thanks for your help

DEAR

SW Version: F4BP-7J104-BB         
Serial number: 030152031722   
Part Number: F4BP-7Z369-BB         
Hardware: AE8P-14F085-AD         
Calibration file: TBCC2BB.H32   
CVN: 27F72885
Completed




FORD FIGO

THNX

Hello
Could anybody make checksum for this file please I already make DPF +SCR Off 

Mercedes Sprinter CRD3P.C0 

Thanks

Can anyone tell me how to read it?
Sure I tried uPD70F3376A and uPD70F3376 it doesn't work.
Skype:namacha-2009

F3376AM1(A)


[url=https://ibb.co/XxWwKryd][/url]

Needed Conti. SID209 Torque Monitoring OFF, can someone? Thanks in advance

hello. Looking for help to make correct DPF EGR solution.

denso sh72543 ecu.

Thx!

Attached Files

mazda_denso_shxx_sh72543_bench_fullbackup_20250405112101.zip

4

2.9 MB

Download

Hey all,
Anyone have Gen1 ecu Toyota RAV4 89663-42R00

HELLO
some one cn change the mileage on ecu 

BOSCH EDC17C84 TC 1782
0 281 034 037

 2017 YEAR
original have  224392 KM I need 175130 KM
i have x-tool but the algo is not supported???
thank in advance
best regard

Attached Files

dflash org.rar

6

7.36 KB

Download

Hi, need help with egr, dpf, adblue off solution on Peugeot Boxer
I tried several solutions - the result is sometimes white smoke
DCM6.2
sw: 9693644980

Attached Files

9809447780_9693644980_ori.rar

1

1.43 MB

Download

HELLO
it is possible to change mileage on this ecu ?
or is there simply the mileage recorded on it?

softdump don't have this algo

VAG TRANSPORTER 2017 year
DELPHY
DCM6.2V
04L 907 445

many thank in advance

I need patch for sandero dash bin. 
Thank you.

Attached Files

sandero.rar

0

69.28 KB

Download

anyone help on this - 2019 1.5 Focus St-Line X Tdci
code of P026e charge air coolant cooler pump - when i check the garage system it seems to indicate an ecu failure

Hi everybody, can someone remove dtc from ecu magneti marelli IAW 5AFN8? Thank you 

DTC is U1601

Attached Files

IAW 5AFN8 HW606 FLASH U1601_IntFl.zip

1

123.24 KB

Download