Ned adapt used ecu... crash status unknown !
Orig ecu same number water damaged . ORIG ..T30223532 DATE...19.0318
USED
0285014640
T30133079
DATE 18.11.18
VAEEQZ
I have a 2012 Octavia with 1.6TDI CAYC 105HP and DSG DQ200 Gearbox.
I am looking for a flash tune that improves the overall behavior (shift points, shift speed etc)
The car used to drive with very low revs and had no response (7th gear at ~60km/h).
Now I have an updated flash with a new Drive Mode table that consists of the average of the Original Drive Mode and Sport Mode.
The problem is 80% solved let’s say, but now there are some specific situations when it hangs the gear way to much (especially when climbing a hill) instead of shifting for a more dynamic feel.
Hello guys, i am looking pops&bangs and while the car is stationary Rev limiter increase for Ford Focus St 2.5 Mk2 if someone share damos or mappack will be good. thanks
Guys , i have issue with a Bentley Flying Spur 2015
Obviously car had rear damage, and repairs was disaster.
I have warning message on dash "Rear spoiler system fault"
and as far as i know, this model does not come with rear spoiler, but continental GT does.
Probably some module has been replaced and car is looking for a spoiler now.
I have Launch and VCDS, also ODIS vas5054. After looking for option to disable such spoiler, i'm unable to find any!
Can gateway coding, Trunk module coding, adaptations etc. can't find a way to disable it.
Anyone familiar with this, or should replace trunk module maybe?
Offering EGS51 Coding String Calculation Service
I'm offering a service to calculate new coding strings for your EGS51 transmission control unit with custom translation ratios.
How it works:
Simply post your current coding string or post your EPROM Dump
Tell me your desired gear ratio translation
I'll calculate the new coding string for you
Implementation is on your side
What you get:
Custom calculated coding string based on your specific needs
Quick turnaround time
Reliable results
This service can help those who have changed their differential ratios and need to update their transmission control unit accordingly.
In return, I only ask for:
A thank you if the service helps you
Some reputation points if you're satisfied
Please provide all necessary information when requesting this service to ensure accurate calculations.
Looking forward to helping fellow community members!
Hello everyone.
I need map pack for my BMW X3 E83 M47 EDC16C31 euro 3.
I attached my file. Does anyone have a map pack? I use winols 2.24.
And another question. Is there working solution for asmod or another method for maf off (maf to map)?
I need Immo Off for Iveco Eurocargo 100E19. Truck shows Code when try to start. Sometimes after cut batteries 5 minutes later key is recognized again.
Want to kill Immo.
hey anyone can do multimap on toyota hilux 2.8 (ecu gen3) ?
is it possible ? i see something on web but not sure if is done on oem ecu...
already have tuned.... stg2 hardcut hardsmoke etc...
BR henrique
Posted by: PADRE - 03-31-2025, 04:49 PM - Forum: Selling Box
- No Replies
Hello
Power Wizard 1.1 and Power Wizard 1.1+ FG Wilson Hours (Reduction - Correction) is now available using EST Perkins !
no Need to open ECM anymore.
Working On other Model EMCP and other Power Wizard IF YOUR ECM STUCK AT 0 HOURS CAN BE FIXED ALSO!
Hello guys. I need your help. My car is BMW F10 528i USA. EKPM3 module was broken yesterday, so I bought a used module with identical codes from another car. My car starts, but I get a fuel supply error, the engine only works well at 3000 rpm. Do I need to adapt it or do I need to code it? I have ISTA D and Esys. All advice is very welcome, thank you.
S-AV61-12A650-GD
