can i have immo off please. Tried many solutions with p1570 on ecm and b104a00 showing on instrument cluster. Dash still shows safe. attached are files. Car will start off starter relay with this file but not off button.
hi mercedes X , 2018year, dtc from airbag B00A0- OCCUPANT detection sensor, possible erase from ecu airbag but emulator, 0285014306 , 988205xb0a, thanks
Hello
I have porsche cayenne E3, need flash file for steering wheel electronics (9y3953513q)
I have internal fault and steering angle always show 819 degrees. Mcu is NEC 70f4000am. Cant read with vvdi. Is there flash file or something ? Willing to pay.
Hello,
I need a dump for a Avensis 2.0D T25. After km change damp was damaged. Eeprom 93c46W. And need km to 257431.
Attached dump was readed now.
Thanks
Had problems with easytronic 3 and was sent to repair. They found clear problems and fixed them. Now car start and moves.
However from standstill it is jerky and couple times stalled when leaving from standstill.. Clutch relearn and clutch bleeding has been done multiple times.
But the bigger problem is SUPER slow shifts like 3-7seconds and poor shifting. Sometimes very little gear grinding and its just very slow and confused especially on downshifts.
Tried to SPS program new software but newest software was installed already. Then I did the configuration with sps programming and the first part of relearning goes fine where it wants you to press braek pedal, but the second part of relearn where it says you to not press brake pedal always fails af 20seconds remaining. It shifts gears once or twice at the end of relearn and then fails with a text saying "Programming failed, conditions not met" And if you shut of key wait for car to powerdown and try again samething happens everytime at the same point.
Is it acting up because problem with easytronic actuator or something inside transmission or because the sps programming configuration fails? but why it fails?
It seems like either problem with easytronic or it doesnt know gearshift points or something? It shift gears with scantool, so idont thing the transmission itself has problems..
Hello, I have unit that I need the theft code to replace my old hu for my car. Anyone can help me get me the code please [font="MHH Font", Calibri, sans-serif]Sn BEM111FS027226[/font]
